Hitachi D13VG Cordless Drill User Manual


 
English
12
7. Mounting and dismounting of the bit
For keyed chuck (Fig. 2)
(1) Open the chuck jaws, and insert the bit into
the chuck.
(2) Place the chuck wrench in each of the three
holes in the chuck, and turn it in the clockwise
direction (viewed from the front side). Tighten
securely.
(3) To remove the bit, place the chuck wrench
into one of the holes in the chuck and turn it
in the counterclockwise direction.
For keyless chuck (Fig. 3)
(1) Open the chuck jaws, and insert the bit into
the chuck.
To open the chuck jaws, hold the ring while
turning the sleeve in the counterclockwise
direction (viewed from the front side).
(2) Firmly grasp the ring and turn the sleeve in
the clockwise direction. Tighten securely.
(3) To remove the bit, firmly grasp the ring and
turn the sleeve in the counterclockwise
direction.
(4) If it is hard to loosen the sleeve, fix the
spindle using the open-end wrench, hold the
sleeve firmly, and turn it in the loosening
direction (counterclockwise when viewed
from the front). (Fig. 4)
8. Installing the side handle
For D10VG and D13VF
A Side handle is supplied with drill.
It can be installed on either side of the tool for
right or left handed use.
To install the side handle, thread it into the
socket on the desired side of the tool and
tighten it securely. (Fig. 5)
For D13VG
The large torque of the motor for this drill can
result in considerable reaction to your arms
during drilling work. Accordingly, make
absolutely sure before use that the side
handle and the handle joint are completely
installed. (Fig. 6)
9. Check the rotational direction (Fig. 7)
The bit rotates clockwise (viewed from the
rear side) by pushing the R-side of the push
button.
Fig. 2
Drill chuck
Chuck
Wrench
Tighten
Loosen
Fig. 5
Side Handle
Loosen
Tighten
Fig. 3
Sleeve
Ring
Tighten
Loosen
Fig. 4
Open End
Wrench
Loosen
Fig. 6
Side
Handle
Loosen
Tighten
Handle
Joint
Loosen
Tighten