Filter
Top Products
English
17
OPERATION
1. Using the hook (Hook with bit holder or Light equipped hook)
WARNING: When using the hook, pay sufficient attention so that the main equipment
does not fall. If the tool falls, there is a risk of accident.
CAUTION:
● Do not attach the tip tool except phillips bit to the tool main unit when carrying the tool
main unit with the hook suspended from a waist belt.
Injury may result if you carry the equipment suspended from the waist belt with sharp
tipped components such as drill bit attached.
The hook can be installed on the right or left side
and the angle can be adjusted in 5 steps between
0° and 80°.
(1) Operating the hook
(a) Pull out the hook toward you in the direction of
arrow (A) and turn in the direction of arrow (B)
(Fig. 5).
(b) The angle can be adjusted in 5 steps (0°, 20°,
40°, 60°, 80°).
Adjust the angle of the hook to the desired
position for use.
(2) Switching the hook position
CAUTION:
● If the tool falls, there is a risk that malfunction and/
or physical damage can occur. It is recommended
that you also use fall-preventing wires, etc.
● Incomplete installation of the hook may result in
bodily injury when used.
(a) Securely hold the main unit and remove the
screw using a slotted head screwdriver or a
coin (Fig. 6).
(b) Remove the hook and spring (Fig. 7).
(c) Install the hook and spring on the other side
and securely fasten with screw (Fig. 6).
NOTE:
Pay attention to the spring orientation. Install the
spring with larger diameter away from you (Fig. 8).
1.1 Using the bit holder (Hook with bit holder)
⅜ Installing the bit
Slide the bit from the side, and then insert firmly
until the groove on the bit locks in the protruded
section of the hook.
4
(B)
Fig. 7
Fig. 5
Fig. 6
Loosen
Spring
Hook
Screw
3
2
1
5
Hook
(A)
Screw
Fig. 8
Larger diameter faces away