Hotpoint RFA16 Freezer User Manual


 
Read the rest of these instructions to get the best from your appliance and
remember to fill in your guarantee registration.
GETTING STARTED:
To ensure that your fridge freezer runs reliably and efficiently follow these steps.
SAFETY &
INSTALLATION
CONTROLS
USEFUL ADVICE
CLEANING &
MAINTENANCE
SERVICE &
GUARANTEE
TROUBLESHOOTING
Choose a location for your
fridge freezer,away from
any heat sources and
allow adequate
ventilation - 100mm
(4 inch) gap above.
Level the fridge freezer by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
Before plugging in and
switching on,leave the
fridge freezer in its final
location for at least 15
minutes to allow it to
settle.
Your fridge freezer is now
working.
If after 24 hours your
fridge freezer is not
operating as you want,
refer to the
TROUBLESHOOTING
section.
Move the fridge freezer
into position,using the
sides of the cabinet.
Take care to avoid
damaging the refrigerant
circuit pipe work on the
rear.
Plug in and switch on.
Allow the fridge freezer to
cool before placing food
inside.
All food in the fridge
freezer should be
covered.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Keep this Book in a safe place for quick reference.
NB.The spanner is for illustration
only and is not supplied with the
fridge freezer.
FRIDGE FREEZER - MODELS RFA17, RFM17, RFA16, RFM16
INSTRUCTIONS FOR INSTALLATION & USE
This appliance must not be installed in a location where the room temperature
drops below 10
o
C, or exceeds 32
o
C, for prolonged periods.