Ingersoll-Rand 67386 Stud Sensor User Manual


  Open as PDF
of 2
 
OPERATOR’S MANUAL
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
CYCLE SENSOR KITS
(CLOSED ELECTRICAL CONTACT TYPE)
FOR 3/8” & 1/2” DIAPHRAGM PUMPS
67386
RELEASED: 3-28-06
REVISED: 8-2-10
(REV. 03)
CYCLE SENSOR KITS
67386 can be used on the following diaphragm pumps:
3/8” -- PD03P-XXX-XXX
1/2” -- PD05A
-XXX-XXX-B, PD05P-XXX-XXX-B and PD05R-XXX-
XXX-B
GENERAL DESCRIPTION
The ARO diaphragm pump cycle sensor kits provide a closed contact
output each time the pump completes a cycle. This signalmay be used
to record cycles for maintenance purposes or batching if the discharge
volume of each complete cycle is known.
Someparts ofthe pumpmustbe replacedwith thoseincludedin thekits
to enable the activation of the switch.
OPERATION
Maximum Operating Voltage - 200 V DC.
Switching Current - 0.5 Amps
Once the kit is installed in the pump, it may be interfaced with a control
device in the following ways:
As a SOURCING switch (see figure 1) for use with PLC’s.
As a SINKING switch (see figure 2) for use with PLC’s.
As a closed contact switch (see figure 3) for use with meters.
INPUT
INPUT
INPUTS
Figure 1
Figure 2
Figure 3
+V
Sourcing Switch
Sinking Switch
Closed Contact Switch
67386 SENSOR INSTALLATION
Refertofigure4.
1. Remove (134) bolts from the major valve and remove (135) valve
block.
2. Remove (141) valve plate and (140) valve insert from the valve
block.
3. Remove (136) plug and (111) spool. Assemble 67407 spool and
(136) plug into valve block. NOTE: Apply Lubriplate (94276) to all
“O” rings, “U” cups and mating parts.
4. Replace (140) valve insert and (141) valve plate in valve block.
NOTE: Assemble (140) valveinsert with“dished” side toward(141)
valve plate.
5. Assemble 96563 adapter (with 95276 sensor attached) to valve
block. Attach (135) valve block to (101) motor body, using (134)
bolts. NOTE: Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm).
141 k
140
135
. 134
Identification dot this side.
k Assemble with identification dot toward (132) gasket.
.Torque to 15- 20 in. lbs (1.7 -2.3 Nm).
g Included in67386 kit.
Figure 4
Included butnot shown:
94276 Lubriplate grease
95275 Magnet
Y325-29 (2) g
95276 g
96563 g
111
136
132
67407
g
INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET – BRYAN, OHIO 43506
(800) 495-0276
FAX(800) 892-6276
© 2010 CCN 15257850
www.ingersollrandproducts.com