Filter
Top Products
11
WARNING
Before plugging in the line cord, make sure that the power
switch is in the OFF (O) position.
5. Unwrap the line cord.
6. Plug into a 115V/60Hz wall outlet.
7. Insert the nebulizer mouthpiece into the top of the nebulizer.
NOTE: Before attempting to start a cold unit, let the unit reach room temperature in
a heated area.
8. Press the power switch ON ( I ) to start the compressor.
9. Place mouthpiece between your teeth and close your mouth
(FIGURE 3).
10. As aerosol begins to flow, inhale deeply, slowly, and hold breath for
10 seconds. Then exhale slowly through the mouthpiece.
NOTE: Before storing supplies between treatments, clean and dry nebulizer.
(Refer to Maintenance Section in this manual). Tighten caps on medication jars.
NOTE: In the event a substantial increase in back pressure is achieved, i.e.
kinked tubing, an audible "pop" or air leak may be heard. A relief valve has
been included to reduce possible damage to the compressor; which closes once
the back pressure has decreased.
FIGURE 3 - USING
THE NEBULIZER
FIGURE 2 - ADDING
LIQUID MEDICATION
TO THE NEBULIZER
4. Add liquid medication to the nebulizer according to your
physicians prescription (FIGURE 2).
OPERATION