Lenco Marine HP-2010 Welder User Manual


 
RESISTANCE SPOT WELDERS
...
LENCOPULL Portable Dent Pulling Systems
LP-2000
The Mark II welder makes factory type spot welds in the shop. Simple to operate
by pressing the two electrodes against the work and pressing the trigger.
• Time of welds is automatic by solid state electronics
• Protected control panel
• On/Off indicating switch
• Maximum welding capacity is 20 ga. autobody steel
• Tool storage space
• Easy portability with wheeled car t
• Primary voltage is 208/230 single phase 50/60 Hz,
50 amp or 480 single phase 50/60 Hz, 30 amp
• Shipping weight is 110 lbs.
• 50’ Power cable
• Star weld tip welds directly to the work piece
• Built on slide hammer for one step operation
• Can shrink light gauge metals
• Available with primary voltage of 208/230 single phase 50/60
Hz, 20 amp or 120 volts 50/60 Hz, 30 amp
• 7’ welding & 7’ ground cable leads
• Shipping weight is 64 lbs.
• 25’ Power cable
Model Item Code No. Volt Capacity
L-4000 20400 208/230
L-4480* 20480 480
Model Item Code No. Volt Capacity
LP-2000 20720 208/230
LP-2000 20820 120
HP-2010
• T-handle can be used for short controlled pulls
• Lightweight, padded grip for comfortable usage
• Can shrink light gauge metals
• Available with primary voltage of 208/230 single phase 50/60
Hz, 20 amp or 120 volts 50/60 Hz, 30 amp
• 10’ welding & 7’ ground cable leads
• Shipping weight is 64 lbs
• 25’ Power cable
Model Item Code No. Volt Capacity
HP-2010 20710 208/230
HP-2010 20810 120
Lenco dent pulling systems allow for
any type of pull in any situation.
Systems have their own specially
designed transformers and are
available in 120 or 230 VAC.
*w/o power cable
®®
The LENCOSPOT MARK II