Leupold MT-100 Saw User Manual


 
4
left side of the saw’s frame and loosening the set screw on the brass arbor. Move the
wheel to the correct position, check with the ruler or scale, and secure the set screw.
Blade Tension
Proper blade tension is important for ease of cutting and obtaining maximum blade life. The
tension springs lessen the stress that twists and pulls put on the blade to maximize blade life. All
MTI saws have tension springs preset for a blade 37.7" in circumference (+ or - .005"). That is the
exact dimension of MTI brand blades. If you use an MTI blade you should never have problems
with tension. Some competitors make blades that are only 37.2”. These blades will have too
much tension which could shorten blade life. We highly recommend the use of MTI brand blades
for all MTI brand saws.
Installing the Work Table
Place the metal table on the table supports with the split facing the front of the saw. Use a Phillips
screw driver to attach the table using the (4) 10-24 1/2” phillips screws. Take care not to
overtighten.
Our patented BladeSert™ eliminates the need for upper blade guides by providing blade support
where it is most crucial: at the point of sawing. Place the BladeSert™ into the work surface
making sure the blade passes through the slot and the split faces the saw front.
IMPORTANT NOTE: The BladeSert™ will wear with saw use. The slot that the blade passes through
will widen over time. Using a worn BladeSert™ allows for excess play in the blade and the blade
becomes more likely to break. How fast this happens will depend on use and your sawing style.
You should check the BladeSert™ for wear each time you use the saw. Immediately replace the
BladeSert™ when it begins to show signs of widening and wear. It is also a good practice to use