Filter
Top Products
Date:
6/1/2008
MSDS No.:
CAN-F30
Trade Name:
Lincolnweld 801
Sizes: ---
Supersedes: 11/1/07
M A T E R I A L S A F E T Y D A T A S H E E T
For Weldin
g
Consumables and Related Products
Conforms to Work
p
lace Hazardous Materials Information S
y
stem
(
WHMIS
)
Rev. November, 1988
Section I & II - Preparation and Product Information
Product Type: Submerged Arc Flux
Representative Classifications: None
The Lincoln Electric Company of Canada LP
179 Wicksteed Avenue
Toronto, Ontario M4G 2B9 CANADA
Phone: (416) 421-2600
Prepared by The Lincoln Electric Company, Cleveland, Ohio, USA
(216) 481-8100, on the date shown above.
Section III - Hazardous Ingredients (1)
I M P O R T A N T !
This section covers the materials from which this product is manufactured. The fumes and gases produced during welding with the normal use of this
product are covered by Section VII; see it for industrial hygiene information.
CAS Number shown is representative for the ingredients listed.
(1) The term “hazardous” in “Hazardous Ingredients” should be interpreted as a term required and defined in the Hazardous Products Act and
does not necessarily imply the existence of any hazard.
Ingredients: CAS No. Wt. %
TLV
mg/m
3
LD
50
(Route/Species)
LC
50
mg/m
3
(Route/Species)
Magnesite 1309-48-4 30-60 10
Not Available Not Available
Aluminum oxide and/or Bauxite 1344-28-1 10-30 10
Not Available Not Available
Mineral silicates 1332-58-7 10-30 5**
590 g/kg LDLo
(o
r
a
l
/
r
at)
r
ep
r
oduct
iv
e
Not Available
Fluorides (as F) 7789-75-5 10-30 2.5
4250 mg/kg
(o
r
a
l
/
r
at)
Not Available
Silicates and other binders 1344-09-8 5-10 10*
1153 mg/kg
(o
r
a
l
/
r
at)
Not Available
Manganese and/or manganese alloys and compounds (as Mn) 7439-96-5 1-5 0.2
9 g/kg
(o
r
a
l
/
r
at)
2.3 LCLo
(
inh
a
l
at
i
o
n
/
h
u
m
a
n
)
Silicon and/or silicon alloys and compounds (as Si) 7440-21-3 0.1-1 10*
Not Available Not Available
Iron 7439-89-6 0.1-1 10*
Not Available Not Available
Crystalline-Silica (cristobalite) 14464-46-1 0.1-1 #0.025**
10,000 mg/kg
(o
r
a
l
/
r
at)
Not Available
Notes:
(*) Not listed. Nuisance value maximum is 10 milligrams per cubic
meter. TLV value for iron oxide is 5 milligrams per cubic meter.
(**) As respirable dust. Value for respirable quartz is 0.05 milligrams
per cubic meter.
(LDLo, LCLo) Lowest published toxic
concentration.
(#) Crystalline silica (quartz) is on the IARC (International
Agency for Research on Cancer) and NTP (National
Toxicology Program) lists as posing a carcinogenic risk
to humans.
Section IV - Physical Data
Physical data such as odor, vapor pressure, density, evaporation rate and freezing or boiling points are not listed as they are not applicable
to this product and its use.
Section V - Hazard Data
Non Flammable; Welding arc and sparks can ignite combustibles and flammable products. See CSA W117.2 Section 9.7 as referenced in
Section VIII. Product is inert, no special handling or spill procedures required.
Rev 9/07 (CONTINUED ON SIDE TWO)