Filter
Top Products
Date:
1/5/2009
MSDS No.:
CAN-F27
Trade Name:
MIL 800 HPNi
Sizes:
---
Supersedes: 9/10/2007
M A T E R I A L S A F E T Y D A T A S H E E T
For Weldin
g
Consumables and Related Products
Conforms to Work
p
lace Hazardous Materials Information S
y
stem
(
WHMIS
)
Rev. November, 1988
Section I & II - Preparation and Product Information
Product Type: Submerged Arc Flux
Representative Classifications: AWS F8A6-ENi1K-G-H2
F9A4-ENi5-G-H2
The Lincoln Electric Company of Canada LP
179 Wicksteed Avenue
Toronto, Ontario M4G 2B9 CANADA
Phone: (416) 421-2600
Prepared by The Lincoln Electric Company, Cleveland, Ohio, USA
(216) 481-8100, on the date shown above.
Section III - Hazardous Ingredients (1)
I M P O R T A N T !
This section covers the materials from which this product is manufactured. The fumes and gases produced during welding with the normal use of this
product are covered by Section VII; see it for industrial hygiene information.
CAS Number shown is representative for the ingredients listed.
(1) The term “hazardous” in “Hazardous Ingredients” should be interpreted as a term required and defined in the Hazardous Products Act and does
not necessarily imply the existence of any hazard.
Ingredients: CAS No. Wt. %
TLV
mg/m
3
LD
50
(Route/Species)
LC
50
mg/m
3
(Route/Species)
Magnesite 1309-48-4 30-60 10
Not Available Not Available
Aluminum oxide and/or Bauxite 1344-28-1 10-30 10
Not Available Not Available
Fluorides (as F) 7789-75-5 10-30 2.5
4250 mg/kg
(o
r
a
l
/
r
a
t)
Not Available
Mineral silicates 1332-58-7 10-30 5**
590 g/kg LDLo
(o
r
a
l
/
r
at)
r
ep
r
oduct
iv
e
Not Available
Silicates and other binders 1344-09-8 5-10 10*
1153 mg/kg
(o
r
a
l
/
r
at)
Not Available
Manganese and/or manganese alloys and compounds (as Mn) 7439-96-5 1-5 0.2
9 g/kg
(o
r
a
l
/
r
at)
2.3 LCLo
(
inh
a
l
at
i
o
n
/
h
u
m
a
n
)
Nickel (metal) 7440-02-0 1-5 1.5
50 mg/kg LDLo
(
in
t
r
a
v
e
n
ous/
m
ouse)
Not Available
Silicon and/or silicon alloys and compounds (as Si) 7440-21-3 0.1-1 10*
Not Available Not Available
Quartz 14808-60-7 0.1-1 #0.05**
200 mg/kg LDLo
(
in
t
r
at
r
ac
h
ea
l
/
r
at)
300 LCLo
(
inh
a
l
at
i
o
n
/
h
u
m
a
n
)
Iron 7439-89-6 0.1-1 10*
Not Available Not Available
Crystalline-Silica (cristobalite) 14464-46-1 0.1-1 #0.025**
10,000 mg/kg
(o
r
a
l
/
r
at)
Not Available
Vanadium alloys (as V) 7440-62-2 0.1-1 .05(@)
10 mg/kg LDLo
(o
r
a
l
/
r
at)
346 mg LCLo
(
inh
a
l
at
i
o
n
/
h
u
m
a
n
)
Notes:
(*) Not listed. Nuisance value maximum is 10 milligrams per cubic
meter. TLV value for iron oxide is 5 milligrams per cubic meter.
(**) As respirable dust. Value for respirable quartz is 0.1 milligrams
per cubic meter.
(@) As V
2
0
5
fume or dust.
(LDLo, LCLo) Lowest published toxic concentration.
(#) Crystalline silica (quartz) is on the IARC (International
Agency for Research on Cancer) and NTP (National
Toxicology Program) lists as posing a carcinogenic risk to
humans.
Section IV - Physical Data
Physical data such as odor, vapor pressure, density, evaporation rate and freezing or boiling points are not listed as they are not applicable to this product and
its use.
Section V - Hazard Data
Non Flammable; Welding arc and sparks can ignite combustibles and flammable products. See CSA W117.2 Section 9.7 as referenced in Section VIII.
Product is inert, no special handling or spill procedures required.
Rev 9/07 (CONTINUED ON SIDE TWO)