Filter
Top Products
8
To secure the blade in place, hold the outer flange with
the offset wrench, then tighten the hex nut clockwise
with the wrench. BE SURE TO TIGHTEN THE HEX NUT
SECURELY.
12
006138
CAUTION:
• Be sure to hold the hex nut carefully with the
wrench. If your grip should slip, the wrench may
come off the hex nut, and your hand could strike
the sharp blade edges.
Installing blade guard
1
2
3
006140
1
2
3
006139
CAUTION:
• Before installing the blade guard, adjust the depth
of cut to its maximum elevation.
Remove the center cover and push the button inside the
hole sideways. With the button so pushed, insert the
blade guard into the blade guard mounting portion
(stay).
The spreader installing location is factory-adjusted so
that the blade and spreader will be in a straight line.
However, if they are not in a straight line, loosen the hex
bolts with hex wrench and adjust the blade guard
mounting portion (stay) so that the spreader is aligned
directly behind the blade. Then tighten the hex bolts to
secure the stay.
1
2
3
4
5
6
7
006141
CAUTION:
• If the blade and spreader are not aligned properly,
a dangerous pinching condition may result during
operation. Make sure they are properly aligned.
You could suffer serious personal injury while using
the tool without a properly aligned spreader.
• NEVER make any adjustments while tool is
running. Disconnect the tool before making any
adjustments.
Installing and adjusting rip fence
1
3
2
006159
1) Fit the hook on the tip of the rip fence into the far
guide rail on the table or sub table (R) and install and
push the rip fence forward so that the fence holder
engages with the nearmost guide rail.
To slide the rip fence on the guide rail sideways, pivot
the knob on the fence holder to the half way of its travel.
To secure the rip fence, pivot fully the knob on the fence
holder.
2) To slide the rip fence on the guide rail sideways,
return the knob on the fence holder fully without pulling
the lever on the knob.
3) To remove it, pull the lever on the knob and pivot the
knob fully forward while pulling the lever.
To check to be sure that the rip fence is parallel with the
blade, secure the rip fence 2 - 3 mm (5/64" - 1/8" ) from
the blade. Raise the blade up to maximum elevation.
Mark one of the blade teeth with a crayon. Measure the
distance (A) and (B) between the rip fence and blade.
Take both measurements using the tooth marked with
the crayon. These two measurements should be
identical. If the rip fence is not parallel with the blade,
1. Hook
2. Knob
3. Guide rail
1. These two
clearances
should be equal
2. Blade
3. Spreader
4. Pressure plate
5. Hex bolts
6.
Blade guard portion
7. Button
1. Blade guard
2. Spreader
3. Antikickback
pawl
1. Blade guard
2. Spreader
3. Blade guard
mounting portion
(stay)
1. Offset wrench
2. Wrench