Filter
Top Products
CAUTION:
Always withdraw the tool from the workpiece before resuming operation. If the tool can-
not be withdrawn, hold the tool firmly when turning on the tool, to overcome
a
strong
reaction
the pointer on the adjusting ring points to a
number on the tool body. The fastening
torque is minimum when the pointer points
to the number 1 and maximum when
it
points to the
at-
marking. The clutch will
slip
at
varying torque levels when the point-
er is set at the numbers
1
to
5.
The clutch
is designed not to slip
at
the
ax-
marking.
Adjusting the fastening torque
The fastening torque can be adjusted in six
stages by turning the adjusting ring
so
that
Pointer
---,
,---
Drill
marking
-
I
I
I1
your material or a piece of duplicate mate
for
a
particular application.
The adjusting ring cannot be locked with the pointer positioned half-way between the
numbers.
Installing set plate
Always install the set plate when using bat-
tery cartridges 1200, 1202 or 1202A. Install
the set plate on the tool with the screw
provided.
Screw
Set
plate
Screwdriving operation
Place the point of the driver bit in the screw
head and apply pressure to the tool. Start
the tool slowly and then increase the speed
gradually. Release the trigger as soon as
the clutch cuts in.
__~
10