Filter
Top Products
ASSEMBLY
Installing or removing driver bit or drill bit
CAUTl
ON
:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it will go. Hold
the ring firmly and turn the sleeve clock-
wise to tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
OPERATION
Switch action
Tool speed is increased by increasing pres-
sure on the trigger.
To
start the tool, simply
pull the trigger. Release the trigger to stop.
CAUTION:
Before inserting the battery cartridge into the tool, always check to see that the switch
trigger actuates properly and returns to the
“OFF”
position when released.
Reversing switch action
This tool has
a
reversing switch to change
the direction of rotation
Slide the reversing
switch to the left for clockwise rotation or
to the right for counterclockwise
CAUTION
*Always check the direction
of
rotation before operation
*Move the reversing switch only after the tool comes to
a
complete stop Changing the
direction of rotation before the tool stops may damage the tool
9