Filter
Top Products
Selecting the action
mode
This tool employs an action mode changing
ring Select one
of
the three modes suit-
able for your work needs by using this ring
For rotation only, turn the ring
so
that the
arrow on the tool body points toward the
anamark on the ring For rotation with
hammering, turn the ring
so
that the arrow
points toward
the
+on
the
ring
For
rota-
tion with clutch, turn the ring
so
that the
arrow points toward the
m3
mark on the
ring
Arrow
Action
mode
'
'
changing ring
I
CAUTION:
Always set the ring correctly to your desired mode mark.
If
you operate the tool with the
ring positioned half-way between the mode marks, the tool may be damaged.
Adjusting the fastening torque
The fastening torque can be adjusted in
16
steps by turning the adjusting ring
so
that
its graduations are aligned with the arrow
on the tool body. The fastening torque is
minimum when the number
1
is aligned
with the arrow, and maximum when the
number
16
is aligned with the arrow.
Before actual operation, drive
a
trial screw
into your material or
a
piece
of
duplicate
material to determine which torque level is
required for
a
particular application.
A
11