Filter
Top Products
3
ENGLISH (Original instructions)
Explanation of general view
1-1. Switch trigger
1-2. Lock button
2-1. Lamp
3-1. Reversing switch
4-1. Action mode changing lever
5-1. Side grip
6-1. Chuck key
7-1. Sleeve
7-2. Ring
8-1. Depth gauge
8-2. Side grip
8-3. Grip base
10-1. Blow-out bulb
SPECIFICATIONS
Model HP1640/HP1640F/HP1641/HP1641F
Concrete 16 mm
Steel 13 mm
Capacities
Wood 30 mm
No load speed (min
-1
) 0 - 2,800
Blows per minute 0 - 44,800
Overall length 303 mm
Net weight 2.0 kg
Safety class /II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE039-1
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model HP1640,HP1641,HP1641F
ENG102-3
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
pA
) : 92 dB(A)
Sound power level (L
WA
) : 103 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG203-2
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode: impact drilling into concrete
Vibration emission (a
h,ID
) : 19 m/s
2
Uncertainty (K) : 2.0 m/s
2
ENG301-1
Work mode : drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENH101-12
EC Declaration of Conformity
We Makita Corporation as the responsible
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Hammer Drill
Model No./ Type: HP1640,HP1641,HP1641F
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009