Metabo TS 250 Saw User Manual


 
17
ENGLISH
3.4 Safety devices
Blade guard
The blade guard (31) protects against
unintentional contact with the saw blade
and from chips flying about.
Always have blade guard installed dur-
ing operation.
Riving knife
The riving knife (30) prevents the work-
piece from being caught by the rising
teeth of the saw blade and being thrown
against the operator.
Always have the riving knife installed
during operation.
Push stick
The push stick (32) serves as an exten-
sion of the hand and protects against
accidental contact with the saw blade.
Always use the push stick if the distance
between saw blade and rip fence is less
than 120 mm.
Guide the push stick at an angle of 20q
… 30q against the saw table's surface.
When the push stick is not used, it can
be hung to the holder provided at the
base's side.
Replace push stick if damaged.
Precision adjustable bevel tilt from -
1.5 q to 46.5q.
Simple release of bevel tilt stop from
0° to -1.5° and 45° to 46.5°.
Steplessly adjustable depth of cut 0
– 77 mm.
All operating elements are located
at the machine's front.
An electronic motor protection shuts
the motor off when it is locked (e.g.
by a blocked saw blade).
Electronic softstart for extended
motor life.
An undervoltage relay prevents the
machine from starting up when
power is restored after a power fail-
ure.
Compact design for quick and easy
transportation.
Mitre fence and rip fence are stand-
ard delivery.
Saw blade and holder with cable
storage.
Pull-out table side extension.
x Lower saw blade fully.
x Set saw blade bevel tilt to 0° and
lock with lock lever.
x Remove add-on parts (blade guard,
dust extraction).
x If possible use original carton for
shipping.
A
Crushing hazard
Use handles provided on sides
of table to carry the machine (33).
Lock pulled-out table side extension
with lock lever.
A
Caution!
Do not carry the machine at the
guards, table side extension or oper-
ating elements!
ON/OFF switch
x To stop = press upper switch button
(34).
x To start = press and hold lower
switch button (35) for 1 - 2 seconds.
3
Note: version 10
In the event of an overload a thermal
overload protection will trip. After only a
few seconds the machine can be
restarted. To restart, first press the
Reset button (36), then the Start button
(35).
Note: from version 11
An electronic motor protection by over-
current detection shuts the motor off
when it is locked (e.g. by a blocked saw
blade). To restart, press the Start button
(35).
Note:
In the event of a power failure an under-
voltage relay trips. This prevents the
starting of the machine when power is
restored. To restart, press the Start but-
ton (35).
Handwheel for setting the depth of cut
The depth of cut can be adjusted by
turning the handwheel (37).
Bevel tilt lock lever
By releasing the lock lever (38) the saw
blade can be tilted from -1.5q to 46.5q.
To keep the set bevel tilt from changing
during cutting, it must be locked again by
the lock lever (38).
30 31
32
4. Special Product Features
5. Transportation
6. Operating Elements
33
35
34
36
37
38