Miller Electric 625 Welder User Manual


 
OM-216 244 Page 16
Foot Installation
1 Leg Screw
2 Leg Washer
3 Ferrule Grip
4 Foot
5 Leg
The foot is available in 3 different sizes
(small, medium, and large) and 2 different
configurations (closed and split). Typically, a
split foot is only used when welding headed
anchors and sheer connectors.
The foot is installed on the ends of the legs.
Unscrew the flat head screws from the ends
of the legs. Place the trim washers on the flat
head screws and place the screws through
the adjustment slots in the foot. Reattach the
screws to the legs.
Leg Installation
6 Flat Side of Leg
7 Leg Set Screw
Insert legs into leg retainers. Line up the flat
side of the legs with set screws Tighten set
screws securely.
4
5-3. Foot and Leg Setup
5
1
2
3
Foot Size Stud Range
Small
Medium
Up to 1/2 in.
5/8 to 3/4 in.
6
7
Make sure flat side of legs face
outside ot gun body to ensure
alignment with set screws.
Part #
219670
219671
1 Ferrule Grip
There are 3 set screws that retain the ferrule
grip or spark shield in the foot. Loosen all 3
set screws.
Push the ferrule grip or spark shield into the
foot. Press ferrule grip firmly into the foot so
it seats against the back stop. Line up the 2
side holes in the ferrule grip with set screws
in the foot. Tighten set screws securely.
. If a spark shield is being used, it is not
necessary to align the spark shield with
the set screws in the the foot.
5-4. Ferrule Grip / Spark Shield Removal and Installation
1