Filter
Top Products
OM−216 244 Page 40
SECTION 12 − OPTIONS AND ACCESSORIES
12-1.Plunge Dampener
The plunge dampener controls how fast the melted stud drops into the molten weld pool.
There are three typical dampeners:
S Soft (D rating)
S Medium (E rating)
S Hard (F rating)
Hard dampeners are typically only used for large diameter, extremely heavy studs.
Foot Installation
1 Leg Screw - 195382
2 Leg Washer - 195381
3 Ferrule Grip (see
Section 12-4).
4 Foot (see Section 12-3).
5 Leg (see Section 12-3).
6 Chuck (see Section
12-4).
4
12-2.Foot and Leg Setup
5
1
2
3
6
12-3.Table For Foot and Legs
FOOT LEGS
Foot Size Stud Range Part Number Length Part Number
Small Up to 1/2 Inch 219670 9 Inch 219655
Medium 5/8 to 3/4 Inch 219671 14 Inch 219656
12-4.Table For Chucks and Grips
CHUCKS GRIPS
Stud Size Standard Chuck Long Chuck Stud Size Standard Grip
1/4 Inch 219658 1/4 Inch 219664
5/16 Inch 219659 5/16 Inch 219665
3/8 Inch 219660 195371 3/8 Inch 219666
7/16 Inch 219661 7/16 Inch 219667
1/2 Inch 219662 1/2 Inch 219668
5/8 Inch 219663 5/8 Inch 219669
12-5.Table For Dampener and Chuck Key
DAMPENER CHUCK KEY
Rating Part Number Part Number
D - Rating (Standard) 217403 219672
E - Rating (Medium) 217404
F - Rating (Hard) 217405