Mitsubishi Electronics HC5500 Projector User Manual


 
1
LCD Projector
HC5500
Controlling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions:
Turning the power ON or OFF
Changing input signals
Inputting commands by pressing the buttons on the control panel and remote control
Menu setting
Connection
HDMI IN-2HDMI IN-1
SERIAL
TRIGGER
COMPUTER IN/
COMPONENT
VIDEO IN
VIDEO IN
S-VIDEO
IN
PR/
C
R
PB/
C
B
COMPONENT
VIDEO IN
AC IN
RS-232C cable
SERIAL
D-SUB 9-pin D-SUB 9-pin
To RS-232C
terminal
Important:
Make sure that your computer and projector are turned off before connection.
Boot up the computer rst, and then plug the power cord of the projector.
(If you do not follow this instruction, the Com port may not function.)
Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.
1) Interface
PROTOCOL RS-232C
BAUD RATE 9600 [bps]
DATA LENGTH 8 [bits]
PARITY BIT NONE
STOP BIT 1 [bit]
FLOW CONTROL NONE
This projector uses RXD, TXD and GND lines for RS-232C control.
For RS-232C cable, the reverse type cable should be used.
2) Control command diagram
The command consists of the address code, function code, data code, and end code. The length of the command
varies among the functions.
Address code Function code Data code End code
HEX 30h 30h Function Data 0Dh
ASCII ‘0’ ‘0’ Function Data
[Address code] 30h 30h (In ASCII code, ‘0’ ‘0’) xed.
[Function code] A code of each xed control move.
[Data code] A code of each xed control data (number) and not always indicated.
[End code] 0Dh (In ASCII code, ‘ ’) xed.