Filter
Top Products
- 15 -
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
●
The battery protection feature activates
immediately before the battery loses its
charge, causing the battery low warning
lamp to ash.
●
If you notice the battery low warning
lamp flashing, charge the battery pack
immediately.
●
If it is started with too little battery power
remaining, the tool may stop operating
without the battery low warning lamp
ashing rst. This indicates that there is
too little battery power remaining to use
the tool, and the battery pack should be
charged before further use.
●
If the tool is subject to a sudden load
during use that causes the motor to
lock up, the overdischarge prevention
sensor may be triggered, and the battery
low warning lamp may flash. The lamp
will stop flashing once you address the
cause of the motor’s locking up and cycle
the trigger.
●
The battery protection feature may
activate when a high load is abruptly
placed on the motor, even if ample
battery charge remains. In this case, both
the battery low warning lamp and LED
light will ash (EY74A1).
●
If both the battery low warning lamp and
LED light flash, reduce the force with
which you are pushing on the driver or,
if using a drill driver, adjust the speed
switch to a lower setting (EY74A1).
Battery Pack Life
The rechargeable batteries have a
limited life. If the operation time becomes
extremely short after recharging, replace
the battery pack with a new one.
Battery Recycling
ATTENTION:
FOR Li ion Battery Pack
A Li-ion battery that is recyclable powers
the product you have purchased. Please
call 1-800-8-BATTERY for information
on how to recycle this battery.
[Battery Charger]
Charging
CAUTION:
●
If the temperature of the battery pack
falls approximately below −10°C (14°F),
charging will automatically stop to
prevent degradation of the battery.
●
The ambient temperature range is
between 0°C (32°F) and 40°C (104°F).
If the battery pack is used when the
battery temperature is below 0°C (32°F),
the tool may fail to function properly.
●
When charging a cool battery pack (below
0°C (32°F)) in a warm place, leave the
battery pack at the place and wait for more
than one hour to warm up the battery to
the level of the ambient temperature.
●
Cool down the charger when charging
more than two battery packs consecutively.
●
Do not insert your fingers into contact
hole, when holding charger or any other
occasions.
To prevent the risk of re or damage to the
battery charger.
●
Do not use power source from an engine
generator.
●
Do not cover vent holes on the charger
and the battery pack.
●
Unplug the charger when not in use.
NOTE:
Your battery pack is not fully charged at
the time of purchase. Be sure to charge
the battery before use.