Filter
Top Products
– 22 –
5. If fence is loose when the handle is in the locked
(downward) position, do the following:
• Move the handle upward and turn the adjusting
nut (6) clockwise until the rear clamp is snug.
• Over-tightening the adjusting bolts will cause the
fence to come out of alignment.
NOTE: Two rollers (7) are provided for fine adjustment,
turning left or right.
Fig. JJ
Failure to properly align fence can cause “kickback”
and serious injury.
RIP FENCE INDICATOR AJUSTMENT(FIG. KK)
NOTE: The rip fence indicator points to the scale on
the front of the table saw. Measurement shown by
the indicator will provide the user with accuracy up to
1/16 in. (1.6 mm). Measurement shown is the distance
from the blade to the side of the fence closest to the
blade.
1. To check the accuracy, measure the actual distance
to the side of the rip fence. If there is a difference
between the measurement and the indicator, an
adjustment of indicator (1) is needed.
2. Loosen the indicator screws (2). Slide the indicator
to the correct measurement position on the scale (3),
then retighten the indicator screws.
Fig. KK
WARNING
!
2
1
5
4
3
6
7
PUSH
Micro
Adjustment
Micro
Adjustment
PUSH
1
2
3