Porter-Cable PCB270TS Saw User Manual


 
– 31 –
ACCESSORIES
Since accessories, other than those offered by Porter-
Cable, have not been tested with this product, use of
such accessories with this tool could be hazardous.
To reduce the risk of injury, only Porter-Cable
recommended accessories should be used with this
product.
2WHW DADO INSERT PLATE
A complete line of accessories is available from your
Porter-Cable Factory Service Center or a Porter-Cable
Authorized Warranty Service Center. Please visit our
Web Site www.portercable.com for a catalog or for the
name of your nearest supplier.
WARNING
!
WARNING
!
ACCESSORIES AND ATTACHMENTS
Do not use any accessory unless you have completely
read the Instruction Manual for that accesory.
To avoid the risk of personal injury:
Do not use a dado with a diameter larger than 8 in.
(203.2 mm).
Maximum dado width is 13/16 in. (20.6 mm). DO
NOT USE WIDER COMBINATIONS.
Do not use molding head set with this saw.
Do not modify this power tool.
WARNING
!
For assistance with your product, visit our website at www.portercable.com for a list of service centers, or call the
Porter-Cable Customer Care Center at (888) 609-9779.
PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION
Blade does not raise or
tilt
freely.
1. Sawdust and dirt in elevation/tilting
mechanisms.
1. Brush or blow out loose dust and dirt.
Blade does not come
up to
speed. Reset trips
too easily.
1. Extension cord too light or too long.
2. Low house voltage.
1. Replace with adequate size cord.
2. Contact your electric company.
Machine vibrates
excessively.
1. Saw not mounted securely to workbench.
2. Bench on uneven floor.
3. Damaged saw blade.
1. Tighten all mounting hardware.
2. Reposition on flat level surface.
3. Replace blade.
Does not make accurate
45°
and 90° crosscuts.
1. Miter gauge out of adjustment. 1. Adjust miter gauge.