Filter
Top Products
– 8 –
TOOLS NEEDED FOR ASSEMBLY
Supplied
Not Supplied
Medium screwdriver
Phillips screwdriver
Straight edge
Adjustable wrench
Combination square
6 mm hex key
240 VOLT SINGLE PHASE OPERATION
To avoid injury, disconnect the motor from power
source outlet before reconnecting the wire.
The motor supplied with your machine is a dual voltage,
120/240 volt motor. It is shipped ready-to-run for 120 volt
operation. However, it can be converted for 240 volt
operation, reconnect the motor wire as the wiring diagram
on page 28.
A qualified electrician should do the conversion, or the
machine can be taken to an Authorized Service Center.
When completed, the machine must conform to the
National Electric Code and all local codes and
ordinances.
The machine is converted by re-wiring the motor
for 240 volts, installing a 240 volt plug on the power
supply cord and replacing the switch with one that is
rated for 240 volt operation.
Be sure the 240 volt plug is only used in an outlet having
the same configuration as the plug illustrated in Fig. 1.
No adapter should be used with the 240 volt plug.
In all cases, make certain that the receptacle in question
is properly grounded. If you are not sure, have a
qualified electrician check the receptacle.
WARNING
!
CAUTION
!
10, 13, 17 mm hex wrench
Blade wrench