Filter
Top Products
Installation
Firmware Installation
SN0051103-00 A 3-15
A
Using SANsurfer Router Manager to Install Firmware
To install firmware using the SANsurfer Router Manager:
1. Double-click the desired router in the topology display.
2. In the Firmware Upload window, click Select to navigate to and select the
firmware to upload it.
3. Click Start to begin the firmware load process. A message warns you that
the router will be reset to activate the firmware.
4. Click OK to continue firmware installation or click Cancel to cancel the
firmware installation.
Using the CLI to Install Firmware
To use CLI to install the firmware, transfer the firmware image file from a
workstation to the router. Then use the CLI image unpack command to install
the new firmware image:
1. At the workstation prompt, use the ftp command to go to the location on the
router where you want to transfer the firmware image. For example:
C:\fwImage>ftp 172.17.137.190
Connected to 172.17.137.190.
220 (none) FTP server (GNU inetutils 1.4.2) ready.
2. Enter your username and password. For example:
User (172.17.137.190:(none)): ftp
331 Guest login ok, type your name as password.
Password: ftp
230 Guest login ok, access restrictions apply.
3. At the ftp prompt, type bin to set binary mode. For example:
ftp> bin
200 Type set to I.
4. Use the put command to transfer the firmware image file from the
workstation to the router. For example:
ftp> put
isr-6200-3_0_0_5.bin
200 PORT command successful.
150 Opening BINARY mode data connection for
'
isr-6200-3_0_0_5.bin'.
226 Transfer complete.
ftp: 4822816 bytes sent in 0.41Seconds
11878.86Kbytes/sec.
5. Enter quit. The firmware image has been transferred to the router.
6. Log on to the router as an administrator.