Filter
Top Products
36
MAINTENANCE
The following recommended accessories are currently available at retail stores:
089037006914 Dado Throat Plate
089037006703 Outfeed Support
ACCESSORIES
WARNING:
When servicing, use only identical RIDGID re-
placement parts. Use of any other parts may
create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses
with side shields during power tool operation
or when blowing dust. If operation is dusty, also
wear a dust mask.
WARNING:
Before performing any maintenance, make sure
the tool is unplugged from the power supply and
the switch is in the OFF ( O ) position. Failure to
heed this warning could result in serious personal
injury.
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Periodically check all clamps, nuts, bolts, screws, and
belts for tightness and condition. Make sure the throat
plate is in good condition and in position.
Check the blade guard assembly.
To maintain the table surfaces, fence, and rails,
periodically apply paste wax to them and buff to provide
smooth functioning. To prevent work from slipping during
cutting operation, Do not wax the working face of the
miter gauge.
Protect the blade by cleaning out saw dust from
underneath the table and in the blade teeth. Use a resin
solvent on the blade teeth.
Unscrew wing nuts and open the blade cover. Clean saw
dust and wood chips from the blade cover. Close and
secure. (See figure 49.)
Clean plastic parts only with a soft damp cloth. Do
not use any aerosol or petroleum solvents.
LUBRICATION
This saw's motor bearings have been packed at the factory
with proper lubrication.
Clean screw threads and nuts with a solvent recommended
for gum and pitch removal.
Lubricate screw threads, nuts, and bearing points
(including those on the blade guard assembly and miter
gauge).
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
Fig. 49
blade
cover
wing nuts
wing nut