Filter
Top Products
Basic Saw Operations (Continued)
Miter Cut
When a miter cut is required, loosen the miter lock
knob, depress the index spring, and move the saw to
the desired angle, Retighten miter lock knob Do not
stand in front of the saw table Move with the handle to
the miter angle to make the cut
E
/
/
_._ MOVE FEET
I WiTHMITER
ANGLE t
Bevel Cut
Model 113.235220 & 113.235240 Compound
Miter Saw Only:
When a bevel cut is required, loosen bevel lock knob,
tilt the blade to desired bevel angle Lock the bevel lock
knob. Stand to the left side of the handle to make the
cut.
Overriding the Bevel Stops
Use the 0° and 45=bevel stops for precise, repeatable
bevel indexing,
Occasionally, when cutting a bevel or compound cut,
you may need to set the bevel angle a small amount
beyond the 0° or 45° bevel stop, This is very easily
done by pulling the bevel index pin out and locking the
bevel knob,
BEVEL
LOCK KNOB
BEVELINDEX
PiN
REAR, BOTTOM
VIEW FROM BACK
BEVELINDEX
STOPS
17