Filter
Top Products
PARTS
MANUAL
IMPORTANT:
Read the Safety Guidelines and
All Instructions Carefully Before
Operating.
MODEL NO.
919.165200
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
M-165200 Rev. 3/28/97
PERMANENTLY LUBRICATED
AIR COMPRESSOR
SPECIFICATION CHART
These compressors have a dual voltage motor, 120 and 240 volt. They are wired for
120 volt but can be converted to 240 volt operation. Instructions for connecting the
motor operation at 240 volt can be obtained by ordering Kit #K-0191-1.
When converting to 240 volt operation, the attached three-prong 120 volt plug must
be replaced with the three-prong 240 volt plug, which is included in K-0191-1. The
K-0191-1 Kit may be ordered from Sears.
*These compressors can be operated on a 15 amp circuit if:
1. Voltage supply to circuit is normal.
2. Circuit is not used to supply any other electrical needs (lights,
appliances, etc.)
3. Extension cords comply with specifications in owners manual.
4. Circuit is equipped with 15 amp circuit breaker or 15 amp time
delay fuse.
If any of the above conditions can not be met, or if operation of the compressor
repeatedly causes interruption of the power, it may be necessary to operate it from
a 20 amp circuit. It is not necessary to change the cord set.
**A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same
rating as the branch circuit the air compressor is operated on. If the air compres-
sor is connected to a circuit protected by fuses, use dual element time delay
fuses.
Model No.
Horsepower
Displacement CFM
Bore
Stroke
Voltage-Single Phase
Minimum Branch Circuit Requirement
**Fuse Type
Air Tank Capacity - GAL.
Approximate Cut-in Pressure
Approximate Cut-out Pressure
SCFM @ 40 psig
SCFM @ 90 psig
919.165200
5
11.9
2 3/8"
1.35"
120/240
*15 amps
Time Delay
20 gal. ASME
100
130
9.1
7.1