SMC Networks Bonding Range Glue Gun User Manual


 
All information, including illustrations, is believed to be reliable. Users, however, should independently evaluate the suitability of each product or their application. Innosystems makes no warranties as to the
accuracy of completeness of the information, and disclaims any liability regarding its use. Innosystem’s only obligations are those in the standard terms and conditions of Sale for this product, and in no case
will Innosystems be liable for any Incidental, indirect or consequential damages arising from the sale, resale, use or misuse of the product.
Unit 17a, Loughbook Industrial Estate, Bessbrook, Newry, Co Down, BT35 7EE, United Kingdom
t: +44 (0) 28 30 830 006 f: +44 (0) 28 30 837 006 e: sales@innosystems.co.uk w: www.innosystems.co.uk
Inno Adhesion Promoter
Accelerates the curing of Mega Bond PU and Mega Bond
PU Speed.
Inno Adhesion Promoter is a primer with solvents. It serves as an adhesive
agent for the pre-treatment of plastics basing on PP/EPDM, SMC, PC, PA, ABS
and PUR.
IAP
TECHNICAL DATA SHEET
TECHNICAL DATA
Appearance: Aerosol
Colour: transparent/colourless
Density: 0.86 kg/L (+/- 0,04, at 20°C (liquid stage)
Propellant: G.P.L. (propane / butane)
Flammability: Extremely flammable
USER INSTRUCTIONS
- Not suitable for pure PE and PS.
- Shake can well before use.
- The surfaces to be coated must be free of oil, grease, wax, humidity, dirt, separating and caring agents.
- Apply a thin, even layer approximately 25 cm from the surface of the plastic. Leave to dry. An additional application is
recommended.
- Can be over-lacquered with all current lacquer systems.
APPLICATION
- After sanding (granulation: 120) and removing dust, spray the plastic primer thinly onto the plastic surface.
- Allow approx. 10 to 15 min. for evaporation.
- After a short drying period, a second coating layer is recommended.
- Also suitable as a primer for InnoBOND to increase adhesion to different surfaces/materials.
1 of 1