Filter
Top Products
Additional Battery Temperature Sensors (Part #: 808-0232-01) can be installed on
your XC Series or BC Series battery charger. Xantrex recommends that you install
Battery Temperature Sensors on all banks to protect your batteries and to provide
optimal charging of each bank. See the label on the outside of the package for
other Xantrex products compatible with this battery temperature sensor.
Installing Battery Temperature Sensor
To install a BTS:
1. Switch off all devices operating from the battery.
2. Connect the ring terminal on the sensor directly to the negative battery stud,
or use the adhesive backing on the sensor back to attach the sensor to any side
of the battery to be monitored.
Xantrex recommends you mount the sensor directly on the battery stud as it
will be more reliable against vibration and will provide a good thermal
connection to the battery as well.
3. Route the sensor cable to the charger and plug it into the Bank 1 (default if
using only one BTS), Bank 2 or Bank 3 connector on the rear panel.
It may be advantageous to temporarily apply a layer of tape around the
connector to protect its locking tab from catching on something during pulling
and routing.
Battery Temperature Sensor
Installation Instructions
975-0193-01-01
Revision A