1. Manuals
  2. Power Tools Support
  3. Black & Decker Support
  4. Saw Support
Support User Manuals
Question About Black & Decker Saw 9411 Type 1
need a manual...

same problem as the other fellow, blades keep slipping off the wheels. Seems the metal for the wheels is flimsey and doesnt hold them straight.

Asked by hank on 03/07/2009 10  Answers

ManualsOnline posted an answer 15 years, 9 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Mike posted an answer 15 years, 6 months ago

6 Just got a 9411 at garage sale. No manual. Bought new band saw. Put band saw over drive belt and made sure saw was towards back side of wheels and adjusted tension on belt as shown on inside cover. Worked OK after that.
Was this answer helpful?

Jon posted an answer 14 years, 7 months ago

5 You must have rubber tires on all bandsaw wheels. I bought mine new and have used it for many years. Go to Dewalt supplier for rubber bands and a manual. Rubber breaks down from age and needs to be replaced every 2 -3 years and depending on use.
Was this answer helpful?

hank posted an answer 15 years, 9 months ago

3 No that is the drive belt so it has to be there to pull the blade. Seems to be off the back wheel or even the top. Thats why I need a manual to see how to adjust the thing right.
Was this answer helpful?

grant posted an answer 15 years, 9 months ago

0 I have a differnt B&D band saw, but similar design- the bottom wheel is supposed to have a rubber ring (tire) on it to help keep the blade on track (part # 48 in 9411 parts diagram- could it be missing?
Was this answer helpful?

Dale posted an answer 15 years, 4 months ago

0 Make sure the flat washer under the spring on the top blade adjustment knob is almost at the bottom mark. Blade should be almost in center of top wheel after that. If you need a new belt (mine stretched out) it is a DeWalt 137667-00 at eReplacementparts.com or go to Sears Parts Direct.
Was this answer helpful?

Jon posted an answer 14 years, 7 months ago

0 Make sure the rubber tire band is in place on all pulleys. Use the tensioning screws to adjust where the blade runs.. center on pulley by useing Hex screws and thumb knobs. Buy the rubber pulley bands from Dewalt parts supplier.
Was this answer helpful?

Jon posted an answer 14 years, 7 months ago

0 Dewalt /Porter Cable/Factory Service 5999 Crawfordsville Rd, Indianapolis, IN 46224 (317) 243-8308
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual