Bit can be pulled out after releasing spring back to original position and thought I had seated it as deep as possible. Also do I understand correctly to oil the shank of each bit and not the cutting edges? Directions are vague in some respects and refers to numbers not listed on diagram. Do I assume not all bits will fit especially smaller diameter ones with no room for slots?

Asked by Bill on 01/03/2009 1  Answer

ManualsOnline posted an answer 15 years, 10 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.