1. Manuals
  2. Power Tools Support
  3. Makita Support
  4. Planer Support
Support User Manuals
Question About Makita Planer 2030
Changing drive belt on a model 2030...

I need to know how to change the belt on my 2030 model planer jointer,. Thanks Paul

Asked by Paul on 07/26/2010 2  Answers

ManualsOnline posted an answer 14 years, 5 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Tracy Lewis posted an answer 13 years, 9 months ago

0 take off one side of jiner table, then tip over all the say. Look very closely with a flash light and you will see a small allen screw holding a key in place, for both the fly wheel and the connector which holds the large planer shaft true to the joiner shaft. You will need to unscrew the connector, drop it down and then put your belt on. Then back up goes the connector, tighten the screws and you should be back in business.
Was this answer helpful?

Tracy Lewis posted an answer 13 years, 9 months ago

0 I think it may be necessary to remove one of the drums that joiner side -unscrew the 4 screws on the end cap, Easy to pop off the bearing drum. The bearing has to pushed from the insider joiner frame- just pushed out of the housing. Once that is done, easy to slip in the belt, tighten the motor back up, and back to work. Make sure you remove the Allen screw holding the key in the shaft of the 4 prong connector- not knowing that screw was there cost my time and heartache. Screw also on belt flywheel.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual