1. Manuals
  2. Power Tools Support
  3. Other Support
  4. Air Compressor Support
Support User Manuals
Question About Air Compressor 47065
Please help find the manual for this Harbor Freight Tools Air Compressor...

shutting off when in use.

Asked by reseekp on 01/15/2008 9  Answers

ManualsOnline posted an answer 16 years, 9 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Gary posted an answer 15 years ago

5 It's a gasket, I fixed it temporarly with a piece from a rubber glove. Does anyone know were to buy the replacement gasket?
Was this answer helpful?

Wes posted an answer 15 years, 9 months ago

4 I tried to download the manual but couldn't. Would you please replace the link for it? Thanks, Wes
Was this answer helpful?

Bob posted an answer 16 years, 2 months ago

3 alinbuckeye, Not 100% sure yet, but might have fixed my 47065 compressor. At first, I thought maybe the motor was overloading or getting too hot, but it didn't seem to be. So, I decided to try to unplug the breaker/overload switch on the side of the compressor. When I pulled on the two wires slightly, the wires pulled out from the spade terminal connectors (seems like they were not crimped on very good). I then noticed the spade connectors were soldered to the overload switch. So, I used a small screwdriver to pry open the ends of the spade terminal connectors and re-crimped the wires back into those ends. Now, when I run the compressor, it does not shut off. Could it have been poor connections to the overload switch? I am not 100% sure yet, but I ran it for about 20-30 minutes this morning, with no shut-off problems. Before, it would randomly shut off within a few minutes, time after time. I will post another message, if it starts acting up again.
Was this answer helpful?

William posted an answer 16 years ago

3 I have a problem with the Central Pneumatic compressor # 47065 overheating when it is filling the tank. It has gotten so hot that it has melted the plastic muffler. I have checked and re-checked the oil level. All is correct. I have taken the piston apart but I don't know what to look for any way. Does anyone have any suggestions? The compressor is about 4 years old and worked for a couple of years.
Was this answer helpful?

posted an answer 16 years, 6 months ago

3 Good Luck, I hope this helps CSM Robbibaro USA (ret) I found this manual. 47065 AC manual.pdf
Was this answer helpful?

thomas posted an answer 15 years, 1 month ago

3 I have a constant leak of air coming out under the on off switch, under the plastic shroud that states do not remove,takes forever to pump up. How can i get a replacement air outlet valve.
Was this answer helpful?

Bob posted an answer 16 years, 3 months ago

1 I also have a problem with 47065 air compressor, which is shutting off when in use. I can press the reset switch and it runs again for a little while (and then shuts off again). Any suggestions?
Was this answer helpful?

Al posted an answer 16 years, 3 months ago

1 Did you find the answer to the compressor's problem. I have the same issue with mine.
Was this answer helpful?

Rob posted an answer 13 years, 4 months ago

0 At first, my compressor would not turn off. Unpluged the unit, turned back on and still the same problem. The end result: one of the wires leading into the on/off compartment overlooaded and cause a small fire!!!!! Be very careful and look behind the compartment and smell. This is the problem. Im trying to find a replacement part. If anyone knows, please help. Thanks. Robbie F.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual