The unit is a Schumacher SE 4024, 200 Amp, 40 Amp, 10 Amp, wheel style starter/charger. I Accidently pulled the wiring loose from the rear casing which has connectors on the tips of the wires. Unsure where to place the connectors for the black and white wires comming from the (plug/power) source. Green wire is still intact. Thank you in advance for your attention to this matter.

Asked by Antwan on 08/06/2009 11  Answers

ManualsOnline posted an answer 15 years, 4 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
3 The white wire goes just below the red wire on the back of the amp selector switch. The black wire goes on the back of the timer on the side toward the amp gauge.
Was this answer helpful?
2 Just to clarify, you are talking about the SE 4020. The subject line says 4020, but your post says 4024. I am talking about the 4020.
Was this answer helpful?
0 Sorry, wrong white wire. The white wire you are talking about goes to the connector more-or-less in the lower center of the amp selector. Looking from the back, there are 4 pins on the right, 2 on the left, and one sort of by itself in the lower middle with a copper connector running up to the black wire pin. Sorry about the earlier post. That white wire goes down to the transformer. Feel free to let me know if you need anything else.
Was this answer helpful?
0 My Schumacher SE4022 will not charge battery. When I hook up leads the battery tester gauge reads. When I turn it on to charge the ampmeter does not regester and my own multimeter shows no power at the leads. The fan comes on.
Was this answer helpful?
0 I found this manual. Roy.doc
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.