A.
³⁄₄
" (19.1 mm) extending into room
B.Trim
B
A
A. Level
A
■ Use 2" x 4" or thicker lumber for wood frame.
4. Apply wood preservative to the outside exposed surface.
5. Insert the frame in the wall opening. Square and level frame.
6. Attach frame securely to the wall.
Install Cabinet into Wood Frame
1. Remove top channel and both side channels using a ¹⁄₄" nut
driver or socket wrench. Discard top channel and both side
channels.
A. Outside width
B. Outside height
C. Depth
A
B
C
. Insert cabinet into the
ramed wall openin
. the top o
the cbine
should extend ¾"
19.1 mm
into the room. If there is trim, the
abinet should extend
"
19.1 mm
past the trim
.
heck that air conditioner cabinet is tilted to the outside so that
w
t
r will r
n t
th
t
i
.
. Reuse the insulation to seal openin
between cabinet and
r
m
.
7. Use existin
holes in sides and top of cabinet and 7 - #10 x 1"
wood screws
not provided
to attach cabinet to frame.
NOTE
Do not overti
hten screws or cabinet will distort and
provide a poor air seal between cabinet and air conditioner
. Caulk all outside wall openin
s around cabinet.
4.
se a level to check that cabinet is level side to side.
Complete Installation
NOTE: Handle air conditioner carefully and gently.
1. Make sure the free end of the ground wire is outside of the
cabinet.
2. Insert air conditioner into cabinet.
A
A. Make sure the
ree end o
the ground wire is outside o
the cabinet.
¾" Mini
abinet fro
" Thi
k l
m
" Mini
n
w
xt
r
r
u
n
¼" Slo
e down.
iti
n
n
r
in
ownward.
l
outside
or
rainage.
ax. Wall thick
llowed 8 ½
Front edge of louvers must alw
.
Cut two pieces of standard 1" lumber (supplied by installer) to the
i f t d d1"l b ( li db i t
len
th and width required. Place in front and back of bottom sill
hannel.
ecure with nails
supplied by installer
.
to move and install
