20 5. ATTACHING AN ARM STAND
5. ATTACHING AN ARM STAND
(Example)
M4 x 16 mm
500 mm or
less
75 mm
75 mm
Soft Cloth or
Cushion
The L351 can be used with an arm stand by removing the tilt stand and attaching the
arm stand to the terminal.
NOTE
´ Use an arm stand that satisfies the followings.
• When using the L351 with an arm stand,
the arm stand must be VESA approved :
* Use an arm stand with a 75 mm x 75 mm hole
spacing on the arm mounting pad.
* Use an arm stand that is able to support anobject
weighing 8.0 kg.
´ TÜV/GS approved arm stand.
´ Use an arm stand with sufficient stability
(mechanical firmness) to support the weight of the
monitor.
´ Use an arm stand remaining that position where it
is manually moved.
´ Use an arm stand with the ability to tilt the monitor
forward and backward.
´ Use an arm stand less than or equal to 500 mm in
relation to the desk surface when the arm stand is in its
lowest position.
´ Please connect cables after attaching an arm stand.
Setup Procedure
1. Lay the L351 down as shown below. Do not scratch the panel.
2. Remove the tilt stand by loosening the screws (2 pcs of M4 x 10 mm).
