Filter
Top Products
1 ï
2
The manufacturer is not responsible for any modications to the welding •
lter or use with welding shields other than the Speedglas 100 welding
shield. Protection may be seriously impaired if unsuitable modications
are made.
Wearers of ophthalmic spectacles should be aware that in the case of •
severe impact hazards the deformation of the shield might cause the
inside of the shield to come into contact with the spectacles creating a
hazard for the wearer.
APPROVALS
Speedglas 100 has been shown to meet the Basic Safety Requirements
under Article 10 of the European Directive 89/686/EEC and is thus CE
marked. The product complies with the harmonized European Standards
EN 175, EN 166, EN 169 and EN 379. The product was examined at the
design state by DIN Certco Prüf- und Zertierungszentrum (Notied body
number 0196).
Markings
The welding lter is marked with the shade range and optical
classications.
The following is an example (EN 379):
3 / 8 -1 2 3M 1 / 2 / 2 / 3/ EN379 CE
Light shade
Dark shade(s)
Manufacturer identication
Optical class
Diffusion of light class
Variations in Luminous transmittance class
Angle dependency class (optional marking)
Certication mark or number of standard
Note! The above is an example. Valid classication is marked on the
welding lter.
The markings on the welding shield and the protection plates, indicate
safety class for protection against high speed particles. S stands for the
basic requirement for increased robustness, F stands for low energy impact
and B stands for medium energy impact.