3M 500 Stud Sensor User Manual


 
System Operation
Turning the System On
Follow these steps to turn the system on:
1. Ensure that the power cord is connected to a power outlet.
2. Allow 15 seconds for the system to warm up.
Turning the System Off
Remove power from the system by one of the following methods:
Disconnect the AC power cord from the power outlet.
Set the facility circuit breaker for the system to the Off position.
Verifying system operation
Inspect your system daily for proper operation. To verify system operation, walk through the system corridor normally with
a secured library item. This should result in an audible alarm and a flashing alarm light at the top of the lattices. There is
no need for repetitive walk-through testing.
Copyright © 2008. 3M. All rights reserved.
13