ADIC Version 2.7 Tool Storage User Manual


  Open as PDF
of 7
 
Page 1
Page 2 Page 3
Reports and Queries
Copyright © 1996-2006 by ADIC. All rights reserved.
6-00361-14 Rev A. ADIC Technical Assistance Center: in North America,
call toll-free: 1-800-827-3822; in Europe, call toll-free: 00800-9999-3822;
outside North America, go to the ADIC website at www.adic.com/contact
for a complete list of toll-free numbers by country. Technical Support:
www.adic.com/techsup.
Command Options Description
fsfileinfo Reports the current location of
files, whether of disk, media or
not in the system.
filename Full path and filename of the
file.
fsqueue View subsystem resource
requests.
[-f ] Reports all files in the queue or
specific files if request
identifiers or filenames are
specified.
[ -m ] Reports media movement for a
request identifier or all media in
the queue.
filename Path and filename of the file.
[ -r requestID ] Identifier of the request to be
reported.
fsmedlist Lists media in a data or storage
area.
[ -c class ] Policy class for which the report
is to be generated.
[ -g ] Reports on blank media in the
general scratch pool.
[ -l ] Lists media in the long report
format.
[ -k ] Lists all media marked for
check out.
[ -m ] Lists all media marked for
removal.
[ -b ] Lists unformatted blank media.
[ -f ] Lists formatted blank media.
[ -j ] Lists all media marked to
contain duplicate files.
[ -p ] Lists all write-protected media.
[ -q ] Lists media with mark error.
[ -a ] Lists all available media.
[ -n ] Lists all media unavailable to
SNMS software.
[ -u ] Lists all media marked as
unavailable but still located in
SNMS system.
[ -s ] Lists all suspect media.
[ -d ] Lists all media located in a
drive.
[ -h ] Lists all media located in its
home slot/bin.
[ -t ] Lists all media transitioning
between locations.
[ -z ] Lists all media exiting a storage
area.
[ -o ] Lists all media checked out of
storage areas.
fsstate Reports the state of drive
components, storage
subsystem, and SNMS
software.
[ componentalias ] Alias for drives and storage
subsystems.
[ -f ] Generates a report showing the
status of SNMS software.
Valid states are:
• Active
•Not Active
• Not Available
fsusedspace Reports the total amount of
stored, primary copy data in the
SNMS system (in GB).
Command Options Description
 previous