Agilent Technologies 6035A Welding System User Manual


 
9
1
Introduction
Scope
This manual contains information for troubleshooting the Agilent 6030A, 6031A, 6032A, or 6035A 1000 W Autoranging
Power Supply to the component level. Wherever applicable, the service instructions given in this manual refer to pertinent
information provided in the Operation Manual (P/N 5959-3301). Both manuals cover Agilent Models
6030A/31A/32A/35A; differences between models are described as required.
The following information is contained in this manual.
Calibration and Verification
Contains calibration procedures for Agilent Models 6030A/31A/32A/35A. Also contains verification procedures that check
the operation of the supplies to ensure they meet the specifications of Chapter 1 in the Operating Manual.
Troubleshooting
Contains troubleshooting procedures to isolate a malfunction to a defective component on the main circuit board or to a
defective assembly (front panel, power transformer, or cable assembly). Board and assembly level removal and replacement
procedures are also given in this section.
Principles of Operation
Provides block diagram level descriptions of the supply's circuits. The primary interface, secondary interface, and the power
mesh and control circuits are described. These descriptions are intended as an aid in troubleshooting.
Replaceable Parts
Provides a listing of replaceable parts for all electronic components and mechanical assemblies for Agilent Models
6030A/31A/32A/35A.
Circuit Diagrams
Contains functional schematics and component location diagrams for all Agilent 6030A/31A/32A/35A circuits. The names
that appear on the functional schematics also appear on the block diagrams in Chapter 2. Thus, the descriptions in Chapter 2
can be correlated with both the block diagrams and the schematics.
Safety Considerations
This product is a Safety Class 1 instrument, which means that it is provided with a protective earth terminal. Refer to the
Safety Summary page at the beginning of this manual for a summary of general safety information. Safety information for
specific procedures is located at appropriate places in the manual.