AllTrade 540010 Air Compressor User Manual


 
RISK OF FLYING OBJECTS - Do not direct compressed air stream at people or pets. The powerful compressed air stream can damage
exposed skin and easily propel loose dirt and other small objects at high-speed, resulting in serious injury. Always wear eye protection
that meets ANSI Z28.1 specifications. Use only OSHA approved air blowguns. Never leave a pressurized air compressor unattended.
Shut off air compressor and relieve pressure before performing maintenance or repairs. Do not move the air compressor while the air
tank is pressurized. Never attempt to move the air compressor by pulling on the air hose.
RISK OF FALLING - Portable air compressors can fall from a table, workbench or roof causing damage to the compressor and could
result in serious injury or death to the operator. Always operate air compressor in a stable and secure position to prevent accidental
movement of the unit. Never operate air compressor on a roof or other elevated position. Use additional air hose to reach high loca-
tions.
RISK OF PROPERTY DAMAGE WHEN TRANSPORTING COMPRESSOR - Oil can leak or spill and could result in fire or breathing hazard,
serious injury or death can result. Oil leaks will damage carpet, paint, or other surfaces in vehicles or trailers.
AIR TOOLS AND ACCESSORIES - Do not exceed the pressure rating of any air tools, spray guns, air accessories, or inflatables. Excess
pressure can cause them to explode, resulting in serious injury. Follow the manufacturers recommended pressure settings for all air
tools and air accessories.
SPECIFICATIONS
3.5 Peak HP
11 Gallon Air Tank
Oil Lubricated Direct Drive Pump
Cast-iron Cylinder
Maximum Pressure: 125 PSI
Power: 115V, 60 Hz, 15 Amps
Air Delivery: 4.7 SCFM output @ 40 PSI / 3.0 SCFM output @ 90 PSI
Duty Cycle: 50%
Thermal Overload Protection for Safety
High Flow Regulator for Precision Air Flow Control
Dual Pressure Gauges
Weight: 84 lbs. (38 kg)
Duty Cycle:
Duty cycle refers to the percentage of time a compressor can safely run within a given amount of time expressed as a ratio. Oil lubricat-
ed compressors are typically rated at a 50% duty cycle, meaning that the compressor motor can run about 50% of the total time it is
being used to supply air to a tool. During the “on” time, the motor is running to pressurize the tank. During the “off” time, the motor is
stopped and the tools are running off on the pressurized air stored in the tank. If your air tools are draining pressure off of the tank too
quickly, the compressor motor must run more than 50% of the time the compressor is in use. This can lead to overheating and will sig-
nificantly shorten the life of the compressor.
INSTALLATION AND LOCATION
The compressor must be used on a stable level surface. The air compressor must be used in a clean and well-ventilated area. The com-
pressor requires an unobstructed airflow and must be located a minimum of 20 inches from any walls or other obstructions.
6
WARNING
WARNING
WARNING
WARNING