Filter
Top Products
• For the nailer/stapler to operate, your finger must first be off the trigger and the work contact element
of the nailer/stapler then pressed against the work piece. Once the work contact element is pressed
against the work piece, pull the trigger to drive the fastener into the work piece.
• Release the trigger after each fastener is driven.
• Move the nailer/stapler to the next location and repeat the procedure above.
• Test for proper fastener penetration by driving nails into a sample piece of wood. If the fasteners do not
achieve the desired penetration, adjust the air pressure to a higher setting until the desired penetration
is achieved.
Clearing a Jam from the Nailer/Stapler:
FASTENER JAMMED IN FASTENER DISCHARGE AREA:
• Disconnect air nailer/stapler from air hose.
• Open the nozzle, grab jammed fastener with pliers and remove.
FASTENER JAM INSIDE THE MAGAZINE:
• Disconnect air nailer/stapler from air hose.
• Pull back on the magazine cover.
• Open the nozzle and remove jammed fastener.
• Push the magazine cover forward until the latch catches.
Cleaning the Nailer/Stapler:
DISCONNECT THE NAILER/STAPLER BEFORE CLEANING AND INSPECTION.
CORRECT ALL PROBLEMS BEFORE PLACING NAILER/STAPLER BACK IN USE.
NEVER USE GASOLINE OR OTHER FLAMMABLE LIQUIDS TO CLEAN THE
NAILER/STAPLER. VAPORS IN THE NAILER/STAPLER WILL IGNITE WHEN NAILER/STAPLER IS IN
USE AND CAUSE THE NAILER/STAPLER TO EXPLODE, WHICH WILL RESULT IN DEATH OR SERI-
OUS PERSONAL INJURY.
• Disconnect air nailer/stapler from air hose.
• Remove tar buildup with kerosene #2 fuel oil. Dry off nailer/stapler completely before use.
• NOTE: DO NOT SOAK nailer/stapler in cleaning solutions or damage may occur.
Service and Repairs:
• All quality nailers will eventually require servicing or replacement of parts due to wear from normal use.
These operations should only be performed by a licensed professional technician. Never try to repair
the nailer/stapler by yourself. For service, call 1-800-423-3598.
TROUBLESHOOTING GUIDE
DISCONNECT NAILER/STAPLER FROM AIR SUPPLY BEFORE PERFORMING
ANY SERVICE PROCEDURE.
WARNING
DANGER
WARNING
8