Filter
Top Products
Page 8 AMERICAN SANDERS TECHNOLOGY - American 12 Floor Sander Owner's Manual
Machine Set-Up
To set-up your machine follow this procedure:
1. Familiarize yourself with the machine and read all
danger, warning and caution statements. Make
sure all operators of this machine have read this
Owner's Manual. If they cannot read English,
have the manual explained fully before allowing
anyone to operate the sander.
2. Locate the power supply. The receptacle should
be compatible with the plug. The receptacle must
be grounded and must be fused (30 amp) to avoid
an electrical hazard.
3. Clip the dust bag to the elbow. Cross the strings
on the dust bag and draw tight over the flare on
the elbow. Wrap the string around the elbow and
secure.
4. Wind the power cord through the cable arm.
Keep the power cord out of path of equipment.
How To Install The Abrasive
WARNING: Disconnect power before
changing abrasive.
To install the abrasive, follow this procedure:
1. Prepare abrasive with template supplied.
2. Place backing of abrasive on the template. The
template is marked "This Side Up." Make sure
the marked side of the template is facing up.
3. Cut the abrasive to the exact lenght of the tem-
plate.
4. Align one edge of the abrasive with a notch in the
template.
5. Fold the other end of the abrasive over the end of
the template and crease.
6. Repeat steps 4 and 5 for remaining notch.
7. Lift the drum cover.