AMX Mio-RCC Battery Charger User Manual


  Open as PDF
of 2
 
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
11/08
©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-0147-02 REV: D
9. Press the battery between the rubber pads, with the sticker showing, in
the housing area of the Mio remote. Confirm that the battery is flush with
the bottom of the battery enclosure on the bottom housing.
10. Replace the battery door and slide to lock it in place.
11. Begin charging the battery.
Charging The Mio Remote with the Charging Base
The Mio remotes receive power for charging from a charging base. To recharge
the battery in a Mio remote:
1. Connect the terminal end of the power supply to the bottom external
power port on the Mio remote charging base. See FIG. 2 for the location.
2. Route the cable through the provided channel so that it comes out the
side of the base.
3. Connect the power cord to an external power source.
4. Place the bottom of the Mio remote into the charging base so the contacts
on the device are on top of the charging contacts inside the charging
base. The Power LED on the Mio remote blinks red to indicate it is
charging and illuminates solid red when it is done. Full charge cycle for a
depleted battery is approximately 3 hours.
Avoid placing units equipped with AAA batteries in the charging base.
Changing Battery Modes (Mio R-1 and R-2)
Configuration Mode
The Configuration Mode allows you to set the battery type on the Mio R-1 and
R-2 remotes. To enter Configuration Mode:
1. Press and hold the STOP button and the INPUT button simultaneously.
The two buttons must be pressed within 0.1 seconds of each other and
held down for 2 seconds. The device indicates that you are now in
Configuration Mode. See below for available modes.
Battery Type
2. Pressing button "6" on the remote toggles the battery type between
Normal and Recharge. The display indicates the selected type. The type
of battery dictates the battery type to be selected.
3. Press the EXIT key when you are finished.
Note: Your settings will not be lost in the event your batteries die or are
removed.
FIG. 4 Rechargeable Battery Port on The Mio Remote
Lithium Ion Battery
Rechargeable
Battery
Port Connection
 previous