Filter
Top Products
5
NOTE: Batteries may be kept on a charger until ready for use. The Lifesaver
mode will keep them 100% charged.
LED Indications
The TITAN T2 has two sets of three LEDs (one red, two green). The green status LED
indicates: Steady green – line voltage is present with no power drawn through camera
output; Flashing green - line voltage is present, powering camera; Off – line voltage not
present, camera powered by battery, if there is a battery presently mounted on Titan T2.
The red and green charge status LED’s indicate the charging status of the battery. The
following table identifies all of the LED indications and their meaning. Please note that
the right side charge position will not illuminate the red or green LEDs when power is
being drawn from the 4 pin XLR.
LED INDICATION MEANING
Alternating
Red & Green
Indicates that the TITAN T2 is evaluating the battery and/or
communicating with a DIGITAL battery, loading battery
parameters and determining the appropriate charge routine. A
low voltage (<11V) battery will cause this indication to
continue until the battery reaches safe charging voltage.
Steady Red Indicates that the battery is being held by the TITAN T2 to
stabilize an out-of-range temperature condition.
Or it can also indicate if a non-Anton/Bauer Logic Series battery
has been mounted on the charger. These batteries cannot identify
themselves to the TITAN T2 and will not be charged.
Flashing Red Indicates that the battery is currently under Stage One charge.
Flashing Green
(slow rate)
Indicates that the battery is currently under Stage Two charge.
Flashing Green
(fast rate)
Indicates a fully charged DIGITAL battery is placed on the
charger and a FUL cutoff condition cannot be met. The charger
is VERIFYING that the battery is in a full charge condition.
Steady Green Indicates that the battery is READY and in Stage Three Lifesaver
mode.
Green Status LED
Red/Green Charge Status LED