Filter
Top Products
V INTRODUCTION
Congratulations!
You have just purchased the best Power Earth Auger money can buy. Please read the Jbllowing operating and safety instructions.
Byjbllowing these instructions, this" unit will give you many years &"dependable and carefree service.
The Earthquake ®Model 8900 Earth Augerj_ature a 2HP, 49cc Tecumseh (TC300) engine. The Earthquake ® Model 9000 Earth
Auger feature a 3HP,, 85cc Teeumseh (AV520) engine. These units" are designed_br one-person use when drilling holes' in ice and
one or two person(s) use when used as an earth auger All parts and workmanship &"the gear ease and auger are warranted by
the manu_bcturer A copy of this warranty is"located on the back of this manual. The engine is' covered by a separate engine
manufacturer's warranty. The manual and warranty_br each engine noted above is' also enclosed. Please read the GENERAL
OPERATING INSTRUCTIONS and SAFETY PRECAUTIONS noted below be_bre operating this" unit.
GENERAL OPERATING INSTRUCTIONS
L The gear case has 4 ounces of grease installed at the factory. It is recommended that once a year the gear case be split and the grease
level checked. Add grease only if level of grease is below top of the gears, DO NOT OVERFILL.
Z Attach auger to powerhead with bolt provided,
3, Read engine operating manual and follow instructions for fuel type, starting, etc. BE SURE TO USE PROPER GAS/OIL MIXTURE.
4. The clutch will transfer maximum power after about two hours of normal operation. During this break-in period clutch slippage
may occur, The clutch should be kept free ofoil or other moisture for efficient operation. Each unit is tested atthe factory, but is not
operated for the full break-in period.
5. Dig holes without placing excessive body weight on the unit. The auger operates most efficiently with a shaving action caused by
the weight of the unit itself.
6. Do not use an ice auger in earth or an earth auger in ice. You may use the same powerhead, but a different style auger is required
for each application.
7. When digging in heavy soil, pump the unit with an up and down motion in the hole for every one foot of depth.
8. Do not operate unit in excessively rocky ground. The unit functions well in ground where the rocks do not exceed the size of a
persons fist.
9. The ice auger blade protector should be attached to the auger head when not is use. This will protect the cutting edges of the ice
auger blades.
10. For cold weather operation, store the unit in a cool environment. Transferring the unit from a warm to a cold place can cause the
buildup of harmful condensation.
SAFETY PRECAUTIONS
This symbol points out important safety instructions which if not followed could endanger your personal safety.
Read and follow all instructions in this manual and any others provided with this equipment.
,&
&
,&
Ice blades are very sharp. Use extreme caution
when drilling a hole or replacing the blades.
Do not carry the powerhead/auger between holes
with the engine running.
The auger should not rotate when the engine is
idling. If it does rotate when engine is idling contact
the place of purchase for instructions.
Always keep hands and feet clear of rotating auger.
Do not wear loose clothing while operating the
power auger.
Do not allow children to operate this power auger.
Make sure all first time users have been properly
instructed.
&
,&
,&
Keep all screws, nuts and bolts tight.
Close gas tank cap air vent when engine is stopped.
Do not tilt gas tank indoors or when engine is
running or is hot.
Engine should be shut off before any repairs are
attempted.