Filter
Top Products
5
CAUTION: AS THE SULFATION BREAKS DOWN, THE AMPERAGE MAY RAPIDLY RISE. CONSTANT
ATTENTION MUST BE OBSERVED TO PREVENT SERIOUS OVERHEATING OF THE BATTERY.
4. Lower the charge rate to the lowest rate for the voltage of battery being charged.
5. Charge the battery at this low rate until the electrolyte reaches the fully charged state as described in the tables in your instruction manual.
This may take as long as two or three days.
NOTE: SOME BATTERIES MAY BE SO BADLY SULFATED THEY CAN NOT BE RESTORED TO A NORMAL OPERATING CONDITION,
REGARDLESS OF THE RATE OF CHARGE OR THE LENGTH OF TIME THE CHARGE IS APPLIED. IF THE BATTERY CANNOT BE
RESTORED TO A FULLY CHARGED CONDITION BY A SLOW CHARGING, IT SHOULD BE REPLACED.
WIRING DIAGRAM
MODEL 6006 PARTS LIST
Front leg ................................. 605671
Wheels w/nuts (2)................... 605672
Axle w/nuts ............................. 610052
Base ....................................... 610054
Transformer............................ 610862
Rectifier .................................. 610100
Fan Blade ............................... 610189
Fan Motor ............................... 610190
AC Circuit Breaker ..........................610397
Timer w/knob .................................. 610895
Switch w/knob................................. 611083
Amps Charge Meter........................ 605204
AC Cord ..........................................610696
DC Cable Set.................................. 611084
DC Circuit Breaker (1) ....................610536
Top Panel .......................................611011
Left-side Panel (front view)..... 611031
Right-side Panel (front view) .. 611032
Front Panel............................. 611085
Back Panel ............................. 610977
Handle.................................... 610753
Clamps (1 pair, includes jaws) ... 6202
Jaw kit (repairs 1 clamp) ........ 610970
Parts may be purchased from your local authorized service center (see service procedure at the end of this manual). If you elect to order parts from
the factory you may do so by mail or phone. Minimum order from the factory is $25.00. Orders received that are under the minimum will not be
processed. Taxes and freight are extra and are not considered to be part of the dollar value of the order. We do not have a C.O.D. policy. Cashier
check, Money order, MasterCard or VISA are acceptable. If you use a MasterCard or VISA send only the number and expiration. DO NOT SEND
THE CARD.
MAINTENANCE INSTRUCTIONS
Worn clamps and jaws should be replaced. Worn parts can lead to poor connections and present a safety hazard. See parts list for part number of
jaw and clamp kits. Any Maintenance or repair of this unit that involves disassembly of the cabinet should be done only by a qualified serviceman.
Incorrect reassembly may result in a risk of electric shock when the unit is subsequently used.