Filter
Top Products
12
ASSEMBLY
ASSEMBLING THE RUBBER FOOT AND
WHEELS
See Figure 3.
Mount the rubber feet as shown in figure.
Tighten firmly with an open-end wrench (not included)
to secure it in position.
Mount the wheels as shown in figure.
Tighten firmly with an open-end wrench (not included)
to secure the wheels in position.
Fig. 3
WHEEL
SCREW
NUT
NUT
WASHER
WASHER
SCREW
RUBBER
FOOT
WASHER
WASHER(s)
NUT
ASSEMBLING THE HANDLE
See Figures 4 - 5.
Lower the handle onto the compressor body, as shown
in Figure 4.
Line the holes of the handle with the ones on the slots
of the compressor. Then insert the two knobs and
tighten firmly to secure the handle in position (Fig. 5).
Fig. 4
HANDLE
KNOB
HOLE OF
THE ANDLE
Fig. 5