Filter
Top Products
Chapter 1. Introduction
13
Note: Holes for ATEN Lok-U-Plug cable holders are located around the
sockets. See Securing the Cables, page 23, for further information.
No. Item Description
1 Power Cord Plug the power cord into your AC source.
2 Circuit Breakers (Bank 1
and Bank 2)
As a safety measure, if there is an overcurrent
situation regarding the device’s power, the circuit
breakers will trip. Press the button to recover
normal operation.
3, 4 Power Sockets* 3 x IEC 320 C19
21 x IEC 320 C13
5 Sensor Ports External sensors plug into these two RJ-11 ports.
6 LAN Port and LEDs The cable that connects the eco PDU to the LAN
plugs in here. The Link and LAN LEDs are built
into the LAN port:
Link: Lights GREEN to indicate that a connection
via the eco PDU's RJ-45 Ethernet port has been
established. Flashes to indicate data is being
transmitted.
LAN: Lights ORANGE to indicate 10 Mbps data
transmission speed. The LED lights GREEN to
indicate 100 Mbps data transmission speed.
7 Readout Section, LEDs
and Reset Switch
Details of this section are provided on page 18.
8 Outlet Status LEDs [PE6324 only] These LEDs indicate outlet status.
Lights ORANGE for powered on. Off for powered
off.