Filter
Top Products
10
Appendix
• Clean the charging contacts on the cordless handset(s)
and telephone base or charger each month using a pencil
eraser or a dry non-abrasive fabric.
• Make sure the power adapter and telephone line cords are
plugged in correctly and securely.
• Unplug the power adapter. Wait for 15 seconds before
plugging it back in. Allow up to one minute for the cordless
handset and telephone base to reset.
• The telephone might be malfunctioning. Please refer to
the warranty section of this user’s manual for further
instruction.
The CHARGE
light is off.
• First, try all the above suggestions.
• Move the cordless handset closer to the telephone base. It
might be out of range.
• The telephone line cord might be malfunctioning. Try
installing a new telephone line cord.
• Disconnect the telephone base from the telephone jack
and connect a different telephone. If there is no dial tone
on the telephone either, the problem is in your wiring or
local service. Contact your local telephone company.
There is no
dial tone.
The battery
does not
charge in
the handset
-OR-
Low Battery
is constantly
displayed on
the handset.
• Make sure the handset is placed in the charger correctly. The
CHARGE light on the charger should be on.
• If the cordless handset is in the charger or in the telephone
base but the CHARGE light is not on, refer to The CHARGE
light is off in the section below.
• Remove the battery from the handset and install it in the
spare battery compartment on the side of the telephone base
and let it charge for 16 hours. Then re-install the charged
battery into the handset.
• Please refer to the battery section of this user’s manual.
• If the above measures do not correct the problem, the battery
may need to be replaced.