Filter
Top Products
3
Specifications
Power Supply DC9V-DC16V
Current Draw <120mA
Detecting Distance 0ft – 4.5ft
Sensor Cable Length 18ft
Operating Temperature Range -0°F ~ 176°F
Maintenance
Though your backup system requires minimum care, you should maintain its
condition and performance using the following the guidelines:
• Keep the control box away from moisture, extreme heat or cold.
• Keep the sensors free from snow, ice, and debris.
Diagnostics / Trouble Shooting
Problem Solution
No sound when reverse
gear is engaged.
1. Check if ignition/reverse light on
2. Check power cable connection
3. Check switch on speaker
1 Beep System is functioning correctly
2 Beeps 1 sensor is disconnected/damaged
3 Beeps 2-3 Sensors are disconnected/damaged
4 Beeps No sensors are connected
System beeping without
obstacle behind vehicle
1. Ensure sensor is mounted upright.
2. Remove anything mounted on the vehicle
that may be in the detection area.
3. Ensure correct hole size has been drilled in
bumper.
4. Verify sensor is installed at the correct
height.
5. Verify sensor is in the correct position.
6. Check all connections.
7. Ensure module is not mounted near
electrical components with high current.
8. Verify supporter was used if required
(angled/metal bumpers).